Resetting The Motor Stops On A Sunsetter Awning

The motor could be overheating.

Resetting the motor stops on a sunsetter awning. Unplug or stop using the awning and wait a few minutes. If you need to reset the motor stop position settings refer to the enclosed instructions on how to reset the motor stops. Test the awning for proper operation. Plug the power cord back into the outlet.

Remove four 4 2 phillips screws. A for 5 seconds until the motor jogs then release. These push buttons will be on top of. Press the neutral stop button on the remote.

Plug the awning back in if necessary and try using the awning again. If the remote control stops working with the awning it needs to be reset. A very specific problem but maybe i m not the only one. When the motor stops press and holdthe programming button on the back of the remote transmitter see fig.

Resetting the limit push buttons of the sunsetter motor awnings with motors installed on the right as you face the house appendix b 2. Step 1 push the middle button on the remote control and unplug the awning s power cord from the electrical outlet. Unplug the power cord from the electrical outlet on the wall. Limit how often you open and close the awning as overuse on a hot day could cause the motor to cut out.

From a stepladder locate the limit push buttons on the motor.